What is LED explosion-proof floodlight?

Floodlight is a point light that can be uniformly illuminated in all directions. Its illumination range can be arbitrarily adjusted, and it is represented by a positive octahedron in the scene. In the past, floodlights were the most widely used light source in the production of effect maps. Standard floodlights were used to illuminate the entire scene. In the era of low-carbon lighting, more and more LED explosion-proof floodlights are used. Multiple LED flood-proof floodlights can be used in the scene to produce better results.

Applicable place:

It is mainly suitable for use in flammable and explosive places such as drilling platforms, offshore oil platforms, oil refineries, chemical plants, ramps, oil depots, ships, etc.; applicable to explosive gas environments in Zones 1 and 2 and various indoor and outdoor operations and construction The scene is fixed lighting.

Precautions:

1. Regularly eliminate dust and dirt on the explosion-proof lamp housing to improve the light efficiency and heat dissipation performance of the lamp. The cleaning method can be based on the protection capability of the lamp housing, using water spray (over the shade on the lamp) or using a damp cloth. When cleaning with water spray, the power should be cut off. Do not use a dry cloth to scrub the plastic housing (transparent parts) of the lamp to prevent static electricity.

2. Check whether the transparent parts have been affected by foreign material, whether the protection network has loosened, stripped, and corroded. If so, use should be stopped and repaired and replaced in time.

3. The light source should be turned off in a timely manner to notify the light to be replaced, so as to prevent the ballast and other electrical components from being in an abnormal state for a long time because the light source cannot be started.

4. If there is accumulated water in the cavity of the lamp used in the humid environment, it shall be promptly removed and the sealing parts shall be replaced to ensure the protective performance of the enclosure.

5. When you open the lamp cover, you should press the warning board to open the cover after turning off the power.

6. After opening the cover, check whether the flameproof joint surface is intact, whether the rubber seal is hardened or becomes sticky, whether the wire insulation layer is green and carbonized, and whether the insulation and electrical components are deformed and burned. If these problems are found, they should be promptly repaired and replaced.

7. Before applying the cover, apply a damp cloth (not excessively wet) to light the light and transparent parts of the light fixture to increase the efficacy of the light fixture. A layer of 204-1 displacement rust preventive oil should be applied thinly on the flameproof joint surface. When the lid is closed, attention should be paid to whether the sealing ring plays a sealing role in the original position.

8. The sealed part of the lamp should not be frequently disassembled and opened.