The plastic ball valve for storage should be timely cleaned to make the plastic ball valve look beautiful; for the rust-prone processing surface, the valve stem and the sealing surface should be coated with a layer of rust inhibitor or affixed with a layer of rust-proof paper to protect it; The plastic ball valve inlet and outlet channels should be closed with plastic cover or wax paper to prevent dirt from entering.
There is a plastic ball valve in the warehouse to meet the accounting requirements. They are categorized into different categories, with neat emissions, clear labels, and easy identification. The small valves should be discharged on the shelves according to the model specifications and size order, and they should be classified well. For large valves, they should be placed on the floor of the warehouse, and they should be sorted in order according to the specifications and models. The plastic valve must be placed vertically, and the flange sealing surface cannot be in contact with the ground, nor can it be put together in a pile. To treat extra-large valves and valves that cannot be stored temporarily, place them outdoors in a dry and ventilated place. The sealing surface should be coated with anti-rust oil. The passages should be sealed with sealing caps; some valves have no fillers in the filling mouth to prevent rainwater from leaking. Inside the valve, the filler port should be closed with butter, and the valve should be covered with rain cloth or the like. It is better to temporarily build a protective shed to protect the valve.
For those plastic ball valves that are not used for a long time, if the filling port is packed with asbestos, it should be taken out to avoid electrochemical corrosion with the valve and damage the valve stem. For valves with no packing, the manufacturer will usually be equipped with the corresponding packing, and the inspector should take good care of it. And we must always pay attention to the plastic ball valve's aging period, so that first-in, first-out.
Damaged valve parts such as handwheels, handles, scales, etc. during the handling process must be promptly ordered by the manufacturer to be sent over and must not be missing.
Rust inhibitors and softeners that exceed the specified period of use should be periodically replaced or added as required.
Sealand is a trustworthy manufacturer of Microbend Mass Flow Meter, Microbend Mass Flowmeter, Microbend Coriolis Mass Flow Meter, Microbend Coriolis Mass Flowmeter.
Site Selection for Mass Flow Meter Installation
a) Sensor stays away from mechanical vibration source, for example, pump. Use flexible pipe to connect meter with pipeline if inevitable. The housing of meter must be standalone, out of touch with any other device. There must be 3 times the size of sensor between 2 sensors if there are many flow meters on the same pipeline, to avoid resonance.
b) Do not install sensor on pipeline that easily expands with hot and contracts with cold, especially near expansion joint, which leads to a worse stability.
c) Sensor stays away from industrial electromagnetic field, such as large generator and transformer, better 5m at least. Such device influences the performance of drive coil and pickoffs. Make sure magnetic field intensity less than 400A/m.
d) Sensor shall be installed on lower pipeline, to be easily full of fluid.
e) Make sure Ex-mark meet application requirements if in hazardous area.
f) Build a sunshade if the meter is under direct solar radiation. g) Keep the meter from corrosive liquid.
Microbend Mass Flow Meter, Microbend Mass Flowmeter, Microbend Coriolis Mass Flow Meter, Microbend Coriolis Mass Flowmeter
Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeters.com